›› 2011, Vol. 31 ›› Issue (4): 149-151.DOI: 10.3969/j.issn.1006-1355-2011.04.035

• 6.信号处理与故障诊断 • 上一篇    下一篇

行星齿轮传动装置振动超标问题的分析与排除

龚存忠   

  1. ( 上海船舶设备研究所, 上海 200031 )
  • 收稿日期:2010-11-01 修回日期:2010-12-15 出版日期:2011-08-18 发布日期:2011-08-18
  • 通讯作者: 龚存忠

Analysis of Over-vibration Problem of a Turbogenerator Set with a Planetary Gearbox

GONG Cun-zhong   

  1. ( Shanghai Marine Equipment Research Institute, Shanghai 200031, China )
  • Received:2010-11-01 Revised:2010-12-15 Online:2011-08-18 Published:2011-08-18
  • Contact: GONG Cun-zhong

摘要: 某带行星齿轮减速器的发电机组在满负荷额定转速工况下,出现减速器轴承及发电机后轴承处横向振动偏大的故障现象。通过振动频谱分析,确定了减速器的三个行星轮的装配精度偏差是机组振动偏大最主要的影响因素。在重新拆检复装后,提高行星轮与内齿圈的装配精度,验证试验结果表明,机组振动偏大的故障现象即可消除。

关键词: 振动与波, 啮合传动, 行星齿轮减速器, 发电机组, 三倍频

Abstract: Under the condition of rated load and rated speed operation of a generator set, over-vibration phenomena appeared in the planetary gearbox’s bearing and the rear bearing of the generator. Through the vibration spectrum analysis, the assembling mismatch of the three planetary gears in the gearbox was found to be the main reason of the over-vibration phenomena. After dismounting, inspecting and reassembling, the assembling accuracies between the planetary gears and the internal gear rings were improved. The verification test showed that the over-vibration phenomena disappeared.

Key words: vibration and wave, mesh, planetary gearbox, generator set, three multiplication frequency

中图分类号: