›› 2012, Vol. 32 ›› Issue (1): 72-76.DOI: 10.3969/j.issn.1006-1355-2012.01.017

• 3.运载工具振动与噪声 • 上一篇    下一篇

某商用车发动机悬置静刚度的计算及实验测试

张伟1,上官文斌2   

  1. ( 华南理工大学 机械与汽车工程学院, 广州 510641 )
  • 收稿日期:2011-04-25 修回日期:2011-06-15 出版日期:2012-02-18 发布日期:2012-02-18
  • 通讯作者: 张伟

Static Stiffness Calculation and Experimental Test of an Engine Mount for a Commercial Vehicle

ZHANG Wei,SHANGGUAN Wen-bin   

  1. ( School of Mechanical & Automotive Engineering , South China University of Technology , Guangzhou 510641, China )
  • Received:2011-04-25 Revised:2011-06-15 Online:2012-02-18 Published:2012-02-18
  • Contact: ZHANG Wei

摘要: 以某车用的发动机复合型橡胶悬置为研究对象,分别采用经验计算公式、有限元计算软件和实验测试,取得其三向静刚度值。对比分析这三种静刚度获取方法的相对误差,并给出误差的可能来源。但相对误差均在工程实践误差允许的范围内(<15 %),故得出用这三种求解该悬置的静刚度的方法均具有参考性的结论,其静刚度的结果均对缩短产品开发周期具有一定的价值。

关键词: 振动与波, 发动机橡胶悬置, 三向静刚度, 计算, 实验测试

Abstract: Three methods, including empirical formulas, finite element analysis and experimental test, are employed for studying a composite rubber mount of a commercial vehicle’s engine. Its three-dimensional static stiffness is obtained. Then relative errors of the three methods are analyzed and compared one another. The possible sources of the errors are given. However,the relative errors are found to be within the allowance (<15%) in engineering practice. Thus, as to this specific engine mount, the aforementioned methods for the three-dimensional static stiffness are acceptable and can shorten the cycle of product development.

Key words: vibration and wave, rubber mound of engine, three-dimensional static stiffness, algorithm, experimental test

中图分类号: